Minelab F1A4 Servisní příručka stáhnout pdf (Strana 13)

Operations Manual

Page 13

4.2 Control Box (see Figure 5)

The Control Box can be positioned in one of three locations:

• it can be placed in its control box bag which is attached to the

operator“s waist via two belt loops;

• when the webbing strap is used, the control box bag can be

worn over the operator“s shoulder, or it can hang around the

operator“s neck; or

• it can be attached to the main shaft via a locking bracket located

beneath the handle.

a. If the control box bag is to be used to carry the Control Box either

worn on the belt or as a shoulder pack, position the grommet

(located between the two curled sections of the coil cable) into the

keyway beneath the camlock at the top end of the upper shaft.

(See Figure 6 for correct coil cable positioning.) The plug end of the

coil cable is then connected to the socket marked Coil on the

Control Panel.

b. If the Control Box is to hang beneath the handle on the main shaft,

the mounting block on the Control Box is pushed into the locking

bracket immediately beneath the handle. Rectangular lugs on the

mounting block snap into rectangular holes on the sides of the

locking bracket to hold the Control Box loosely in position. To lock

the bracket, turn the locking pin fully clockwise until it locks in

position. The plug end of the coil cable is then connected to the

socket marked Coil on the Control Panel.

c. To remove the Control Box when it is attached to the underside of

the handle it is necessary to disconnect the coil cable, and then

turn the locking pin counter-clockwise to release the Control Box.

PDF created with FinePrint pdfFactory trial version http://www.fineprint.com

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Žádné komentáře

Minelab F1A4 Servisní příručka Strana 13