Minelab E-Trac Manuál s instrukcemi stáhnout pdf (Strana 47)

Troubleshooting

Detector does not start at all

– Check the condition of the batteries and battery connections.

– Ensure battery pack is fully inserted, and it has clicked into place.

– If using alkaline batteries, check whether they have been loaded

in the right polarity.

– Ensure that you are not holding, or pressing, the Backlight button

while pressing the Power button.

– Ensure that you allowed longer than 1 second between Power O

and Power On.

Detector starts, but switches

o by itself

– Check the condition of the batteries. If necessary, try starting with

batteries known to be in good condition.

– Detector may be too hot. Allow detector to cool down in a

shaded area.

– Try starting the detector with search coil disconnected. If the

detector starts normally, check the state of the coil cable. If it is

damaged, replace the coil. Otherwise return detector for repairs.

No sound

– Unplug the headphones. If there is sound in the speaker but not

in the headphones, check the headphones and their connection.

– Check the Audio > Volume Limit

(a setting of 0 is silent).

– If there is no sound in the speaker or the headphones but the

detector appears to work normally otherwise, return the detector

for repairs.

Erratic noises

– Press the Noise Cancel button or manually select a quiet channel.

– Reduce the Sensitivity.

– Change the orientation of the coil to the vertical plane and rotate

to see if there is a position where the noise is loudest.

If this is the case, it means that there is a source of interference

nearby which must be avoided.

– Check battery charge and battery connections.

– Ensure coil connector is tightened rmly.

– Check headphones and their connection.

– Check for sand or grit between coil cover and coil.

No target response

– Ensure the detector is turned on.

– Check headphones and their connection.

– Check coil connection.

– Check discrimination level. No signal will be given if target is

within black area of screen.

Warranty

There is a two-year parts and labour warranty

for the electronic control box of E-Trac. The

coil has a one year parts and labour warranty.

Refer to the supplier or Minelab for service,

either in or out of warranty. The Minelab

warranty does not cover damage caused

by accident, misuse, neglect, alteration,

modications, or unauthorised service.

For specic details of the Minelab warranty,

please refer to E-Trac’s ‘Product Warranty Card’.

This warranty is not transferable, nor is it valid

unless the enclosed warranty registration card

is returned to Minelab or your Minelab dealer

within 14 days of the original purchase.

Repairs

In the unfortunate circumstance that the

detector needs to be returned to Minelab for

service, please ll out the Minelab Service

Repair Form (or a photocopy of the same)

and enclose it with the detector.

Please supply as much detail about the

fault as possible. This will assist our service

engineers to rectify the problem quickly

and eciently.

1 2 ... 42 43 44 45 46 47 48 49

Komentáře k této Příručce

Žádné komentáře

Minelab E-Trac Manuál s instrukcemi Strana 47

Komentáře k této Příručce

Související produkty a manuály pro Měření, testování a kontrola Minelab E-Trac