Minelab EXPLORER II Servisní příručka stáhnout pdf (Strana 17)

THE MINELAB EXPLORER II

ASSEMBLY

Connecting the search coil to the lower shaft

Figure 2.1–2.3

CAUTION DO NOT attempt to disconnect the coil cable

where it enters the search coil itself. They are shipped

pre-assembled and any attempt to disconnect will void your

detector warranty.

To attach the search coil to the lower shaft:

STEP 1 Place the search coil on a flat surface close to the coil

yoke.

STEP 2 (Figure 2.2, following page) Plug the two black plastic

washers into the recesses provided on either side of the

coil yoke.

CONNECTING THE SEARCH COIL

The search coil transmits electromagnetic signals into the ground and receives

the response.

CONNECTING THE SEARCH COIL

Figure 2.1 Connecting the search coil

to the lower shaft

(Continued next page)

Rubber Washer

Yoke Nut

Coil Yoke

Search Coil

Yoke Bracket

Yoke Bolt

Coil Cable

P0608-A

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 111 112

Žádné komentáře

Minelab EXPLORER II Servisní příručka Strana 17