Minelab F3 Servisní příručka stáhnout pdf (Strana 15)

P0616-A

Electronics

Pack

Lock

Lever

Battery

Pack

Upper

Shaft

Figure 9: Battery Pack Removal

To refit the Battery Pack, ensure that the Lock Lever at the front of

the Electronics Pack is in the unlocked position and position the

Battery Pack on the rail underneath the Upper Shaft.

Slowly slide the Battery Pack towards the Electronics Pack until the

connector is firmly engaged. Secure the Battery Pack by rotating

the Lock Lever in a clockwise motion into the locked position.

2.4 Use of Battery Pack Bag and Extension Cable. If

required, the Battery Pack can be separated from the Upper Shaft

thereby reducing the overall weight of the detector. Using the

bayonet connectors at each end of the Extension Cable, connect the

cable to the Battery Pack and feed the cable through the base of the

Battery Pack Bag before connecting to the Electronics Pack. The

Battery Pack Bag can then be clipped onto a belt worn by the

operator as shown in Figure 10.

P0653-A

Figure 10: Battery Pack Separated from Upper Shaft

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 48 49

Žádné komentáře

Minelab F3 Servisní příručka Strana 15