Minelab The Sovereign Uživatelský manuál stáhnout pdf (Strana 12)

 For Excalibur users, turn the Volume control full clockwise and turn the

Threshold/On-Off control clockwise and adjust for a slight sound.

 Don’t forget to always wear headphones. Adjust Volume to a comfortable level,

if needed, keeping in mind that you could fail to hear faint signals if the volume is

too low.

 Sweep the searchcoil as close to, or touching, the ground at all times while

sweeping side to side at about 1 to 1.5 seconds per foot.

 After a target is found, use the all-metal/discriminate switch in the all-metal

position for pinpointing. Excalibur users, use the disc/pinpoint switch in the

pinpoint position for pinpointing.

 Dig any signal that gives a repeatable, solid, positive response. Listen to the tones

of the various targets you dig and concentrate on learning to associate the tones

with the targets dug.

It’s that simple. Don’t forget to get permission to hunt.

Advanced Set-Up and Go:

Modify the Basic Set-Up and Go instructions to include the following:

 Set the sensitivity control either to Auto or a manual setting. We recommend the

highest counter-clockwise manual setting that still gives a stable operation

without too much falsing.

 Threshold almost silent, just barely able to hear it.

 Your choice of discrimination and notch settings.

You are ready to go. Don’t forget to fill your holes.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Žádné komentáře

Minelab The Sovereign Uživatelský manuál Strana 12