Minelab F3 Servisní příručka stáhnout pdf (Strana 19)

F3 Field Service Manual

Page 19

NOTE

Once a coil pin is fitted to a coil cable, it is not necessary to fit a coil plug retainer.

● Connect the coil cable pull through to the coil plug. (Figure 18)

Figure 18: Coil Pull Through Connected to Coil

NOTE

If a coil pull through is not available a length of string can be used.

● Prior to threading the cable through the shafts, ensure the cable has 52 turns in the

coil cable curly section. (Figure 19)

Figure 19: Coil Cable with 52 Turns

● Slide the coil cable pull through the shafts starting from the lower end until the lower

camlock assembly is resting above the coil. (Figure 20)

Figure 20: Using the Pull Through to Thread Cable Through Shafts

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 41 42

Žádné komentáře

Minelab F3 Servisní příručka Strana 19