Minelab F3 Servisní příručka stáhnout pdf (Strana 34)

F3 Field Service Manual

Page 34

2 8008-0005 CAM LEVER F3

3 8008-0030 WEAR PLATE F3

4 8008-0024 PRESSURE BLOCK MIDDLE CAMLOCK F3

5 4308-0003 CAM LEVER PIVOT PIN

Figure 46: Middle Camlock Assembly

c. To disassemble the upper camlock:

● Using Figure 47 as a guide, use the 3mm T handle hex driver to push out the cam

lever pivot pin (Part 4) from the upper camlock (Part 5).

● Remove the cam lever.

● Remove the upper pressure block by pushing the block out from inside the shaft.

● Remove the upper camlock body from the upper shaft.

3004-0013 CAMLOCK KIT UPPER SHAFT F3

1 8008-0030 WEAR PLATE F3

2 8008-0005 CAM LEVER F3

3 8008-0022 PRESSURE BLOCK UPPER F3

4 4308-0003 CAMLEVER PIVOT PIN

5 8008-0021 CAMLOCK BODY UPPER F3

6 8007-0023

UPPER SHAFT BLACK F3 (not part of Camlock

Kit)

Figure 47: Upper Camlock Assembly

d. To reassemble the upper camlock:

● Refit the upper camlock body to the upper shaft, ensuring that that the square hole in

the camlock body is aligned with the cut-out in the upper shaft. (Figure 48)

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40 41 42

Žádné komentáře

Minelab F3 Servisní příručka Strana 34