Minelab F3 Servisní příručka stáhnout pdf (Strana 23)

F3 Field Service Manual

Page 23

Figure 27: Fitting Speaker Pod onto Handle

● Ensure the wiring loom plug emerges from the handle into the speaker pod in the

correct position as shown in Figure 28.

Figure 28: Correct Position of Wiring Loom Plug (Red Arrow)

● Using the unique screw (Part 4) secure the speaker pod to the handle.

● If the speaker pod socket is dry, smear a small amount of silicon grease around the

shroud to assist in maintaining a waterproof seal.

● By securing the wiring loom plug between thumb and forefinger, gently snap the

speaker pod socket onto the plug and roll back the shroud onto the wiring loom

socket. (Figure 29).

Figure 29: Connecting Speaker Pod to Wiring Loom

● Gently push the upper half of the pod down towards the handle until both halves of

the pod are correctly mated.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Žádné komentáře

Minelab F3 Servisní příručka Strana 23